40oz Mirror Ombre - Sublimation - Laser - Tumblers

40oz handled tumbler for sublimation. Mirror Ombre sublimation coating that produces vibrant colors. For use in a mug press or convection oven.

This 40oz tumbler is perfect for making sublimation creations that are sure to turn heads. Its large capacity is great for both hot and cold beverages. The glitter finish adds the perfect touch of sparkle and shine.

Includes straw
 

Instructions for sublimating:

Convection oven requires the use of shrink wrap to apply pressure during baking, sold separately

***Directions*** PLEASE NOTE: Equipment and your required settings may vary. Please test your equipment using these baseline recommendations.

 Apply for sublimation transfer on the surface of the tumbler using heat tape. For full wrap designs, pull the transfer as tightly as possible around the tumbler, then tape very well along the seam and around the top/bottom of the tumbler. Pull the tape/transfer as tight as possible with no air pockets. If your transfer does not fully cover the tumbler surface, apply blowout/butcher paper to the entire tumbler so that no metal is showing on the sides.

*Tumbler Press* (Equipment settings and functions may vary.     

Press at 360°F for 120 seconds. DO NOT TURN. (Brackets for handle do not allow tumbler to be turned in the press.) If the design is darker, an additional few seconds may be required. Remove the transfer and let cool.

*Convection Oven* (Equipment settings will vary!)

Use a heat gun to shrink the shrink wrap to the tumbler.

Bake in a convection oven at approximately 385-400 degrees F for 5-6 minutes, turning halfway. **If your tumbler touches a metal surface during baking, the shrink wrap will likely melt!

Remove from oven, remove shrink wrap, and transfer. TUMBLER WILL BE HOT!!

No sealant is necessary on sublimation tumblers. *Hand washing is recommended as the high heat in many dishwashers may reactivate the heat and cause it to bleed.